 | | Powered Sensors —Samuel Winchenbach
|
| | | Hello all, I recently purchased "Extreme Mindstorms - An Advanced Guide to LEGO Mindstorms" and I must say it is one of the best books out there for the power user. I have a number of questions regarding powered sensors. First of all, when the RCX (...) (22 years ago, 7-May-02, to lugnet.robotics.rcx.legos)
|
| | | |
| | | | | Re: Powered Sensors —John Barnes
|
| | | | No, the RCX knows nothing about the diodes. That is why devices like the light sensor only send a current signal in the range 0 - 0.32mA back to the RCX. This current then creates a voltage drop across the 10k reference resistor with respect to the (...) (22 years ago, 7-May-02, to lugnet.robotics.rcx.legos)
|
| | | | |
| | | | | | Re: Powered Sensors —Samuel Winchenbach
|
| | | | | ----- Original Message ----- From: "John Barnes" <barnes@sensors.com> Newsgroups: lugnet.robotics.rcx.legos Sent: Tuesday, May 07, 2002 2:23 PM Subject: Re: Powered Sensors (...) the (...) across (...) Ok... lets see if I understand this.... For (...) (22 years ago, 7-May-02, to lugnet.robotics.rcx.legos)
|
| | | | | |
| | | | | | Re: Powered Sensors —Samuel Winchenbach
|
| | | | Ok, I have gotten myself confused again. 0-0.32mA represents a voltage dropbetween 0 - 3.2 volts. Therefore the voltage that the RCX "reads" on theA2D is between 5 - 1.8 volts (1023 - 368 RAW)? To get a reading of 0 (RAW)it seems as though you would (...) (22 years ago, 8-May-02, to lugnet.robotics.rcx.legos)
|
| | | | |
