 | | transfer data failed
|
| Hi there, I use legOS 0.2.4 under Linux and tried (after a few weeks) to download the firmware and get always the follwing error: firmdl3/firmdl: transfer data failed Batteries are brand new, tower was set to short and long dist. nothing helped ... (...) (23 years ago, 6-Aug-01, to lugnet.robotics.rcx.legos)
| | | | | Re: transfer data failed
|
| (...) Hi, i use 0.2.5 under Cygwin and sometimes i experience the same problem. I dont think its a problem with the legOS 0.2.4 distribution. The problem often occurs if its too dark or too bright in your room. It also happens if sender and receiver (...) (23 years ago, 7-Aug-01, to lugnet.robotics.rcx.legos)
| | | | | Re: transfer data failed
|
| (...) I am using 0.2.4 under windoz and have had similar problems. I found that I must use the slow download option (-s) for the firmware to load properly. regards (23 years ago, 7-Aug-01, to lugnet.robotics.rcx.legos)
| | | | | Re: transfer data failed
|
| I use 0.2.5 in windows (djgpp), and can't get by without using the slow download option (-s). If you have lighting problems, perhaps flipping the little switch on the IR tower will help. When I download stuff at school, it helps to have it set to (...) (23 years ago, 8-Aug-01, to lugnet.robotics.rcx.legos)
| | | | | Re: transfer data failed
|
| Hi, thanks for the tips, but nothing helps. I tried 0.2.5, I tried the far and near mode, I changed the lighting conditions -> nothing helped. But I don't think that I fired up my Brick/Tower because the original Lego Software under Windows works, (...) (23 years ago, 13-Aug-01, to lugnet.robotics.rcx.legos)
| | | | | Re: transfer data failed
|
| (...) Did you try slow? (23 years ago, 13-Aug-01, to lugnet.robotics.rcx.legos)
| | | | | Re: transfer data failed
|
| (...) Did you try using the slow mode option ("-s" for firmdl3) as was suggested? (23 years ago, 13-Aug-01, to lugnet.robotics.rcx.legos)
| | | | | Re: transfer data failed
|
| (...) One other thing, did you erase the firmware from the RCX before trying to load legOS? regards Frank Caggiano "The best education for the best caggiano@crystal-objects.com is the best education for all." (URL) Robert M. Hutchins Logo Users (...) (23 years ago, 13-Aug-01, to lugnet.robotics.rcx.legos)
| | | | | Re: transfer data failed
|
| yes I did ... :-( manuel (...) (23 years ago, 14-Aug-01, to lugnet.robotics.rcx.legos)
| |
