| |
Hi there,
I use legOS 0.2.4 under Linux and tried (after a few weeks) to download the
firmware and get always the follwing error:
firmdl3/firmdl: transfer data failed
Batteries are brand new, tower was set to short and long dist. nothing
helped ...
Has anbody any suggestions ??
Thanks
Manuel
|
|
Message has 4 Replies:
 | | Re: transfer data failed
|
| (...) Hi, i use 0.2.5 under Cygwin and sometimes i experience the same problem. I dont think its a problem with the legOS 0.2.4 distribution. The problem often occurs if its too dark or too bright in your room. It also happens if sender and receiver (...) (23 years ago, 7-Aug-01, to lugnet.robotics.rcx.legos)
| | | Re: transfer data failed
|
| I use 0.2.5 in windows (djgpp), and can't get by without using the slow download option (-s). If you have lighting problems, perhaps flipping the little switch on the IR tower will help. When I download stuff at school, it helps to have it set to (...) (23 years ago, 8-Aug-01, to lugnet.robotics.rcx.legos)
| | | Re: transfer data failed
|
| Hi, thanks for the tips, but nothing helps. I tried 0.2.5, I tried the far and near mode, I changed the lighting conditions -> nothing helped. But I don't think that I fired up my Brick/Tower because the original Lego Software under Windows works, (...) (23 years ago, 13-Aug-01, to lugnet.robotics.rcx.legos)
|
9 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
