Subject:
|
Re: transfer data failed
|
Newsgroups:
|
lugnet.robotics.rcx.legos
|
Date:
|
Tue, 7 Aug 2001 10:56:21 GMT
|
Viewed:
|
1584 times
|
| |
|
|
In lugnet.robotics.rcx.legos, Manuel Weindorf writes:
> Hi there,
>
> I use legOS 0.2.4 under Linux and tried (after a few weeks) to download the
> firmware and get always the follwing error:
> firmdl3/firmdl: transfer data failed
>
> Batteries are brand new, tower was set to short and long dist. nothing
> helped ...
>
> Has anbody any suggestions ??
>
> Thanks
> Manuel
Hi,
i use 0.2.5 under Cygwin and sometimes i experience the same problem.
I dont think its a problem with the legOS 0.2.4 distribution.
The problem often occurs if its too dark or too bright in your room.
It also happens if sender and receiver are too close or if there are too far
awy from eachother.
Anyway, i suggest using legOS 0.2.5, because it has fewer bugs. (ok,...maybe
not ;-) )
Hope,
that helps.
Olaf Christ
|
|
Message is in Reply To:
 | | transfer data failed
|
| Hi there, I use legOS 0.2.4 under Linux and tried (after a few weeks) to download the firmware and get always the follwing error: firmdl3/firmdl: transfer data failed Batteries are brand new, tower was set to short and long dist. nothing helped ... (...) (23 years ago, 6-Aug-01, to lugnet.robotics.rcx.legos)
|
9 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
