 | | Full IR packet networking
|
|
When I was looking over version 0.2.0, I saw that one of the features was Full IR packet networking. My question is what exactly does Full IR packet networking do. Does this capability allow individual RCX to be networked, meaning they can (...) (20 years ago, 30-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Kernel size
|
|
Hi Andreas, (...) It is about 22cm x 12cm for the two dimensional kernel. (couldn't resist) Actually, the size of the kernel is sort of unknown until you built it. It depends on your preferences and to some degree of the compiler version you build (...) (20 years ago, 29-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Kernel size
|
|
Hi, I've got a really small question. What's the size of the LegOS Kernel which you have to load on the RCX? Andreas (20 years ago, 29-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Problem
|
|
Trent, Make sure the following files exist in the paths listed below (within the main BrickOS folder): boot\brickos.srec util\firmdl3.exe If those do not exist, then you need to run the configuration routine and MAKE to build the firmdl3 application (...) (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Problem
|
|
(...) You'd be up and running already without a hitch if you used my pre-built installers for cygwin & brickOS. Downloading the firmware using BricxCC is very simple as well. (URL) Hansen (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Problem
|
|
(...) Are you sure you typed "ln"? That should be "LN" but lowercase. It can be easy to confuse "l" with "i". ROSCO (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Problem
|
|
(...) (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Problem
|
|
(...) Hi, try to use this command to install brickOs on your RCX: ./firmdl3 ../boot/brickos.srec Andreas (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Problem
|
|
Hey all, I have winXP and have installed Cygwin and all and have everything i need to install brickOS on my RCX. Althought when i try to install brickOS on my RCX i type the command into the cygwin bash shell and it returns a error. The command is: (...) (20 years ago, 26-Jul-04, to lugnet.robotics.rcx.legos)
|
| |
| | Re: brickOS v1?
|
|
(...) doesn't it do that already with kernel 2.6? I have a serial tower, so I wouldn't know, but it sems logical (as nqc requires that driver and it's just there for me : fc2) Thomas (20 years ago, 24-Jul-04, to lugnet.robotics.rcx.legos)
|
