|
|
 | | Re: LNPD and cygwin
|
| (...) does lnpd work with usb tower under linux ? nanobapt (21 years ago, 17-Apr-03, to lugnet.robotics.rcx.legos)
| | | | | LNPD and cygwin
|
| Sorry if this message is duplicated, but I got an error when publishing and untin now I don't see it published. Hi all, I have the USB tower so by now (because I have a project for the university, and not too much time) I've to use cygwin. Well (...) (21 years ago, 17-Apr-03, to lugnet.robotics.rcx.legos)
| | | | | LNPD and Cygwin
|
| Hi all, I have the USB tower so by now (because I have a project for the university, and not too much time) I've to use cygwin. Well everthing is running fine, but I came with this question: Is is possible to install LNPD (as a deamon) the same way (...) (21 years ago, 17-Apr-03, to lugnet.robotics.rcx.legos)
| | | | | addressing bricks
|
| Hi everyone, I was wondering if anyone could tell me how to address RCX bricks, using LNP. I have been looking at examples of code on lnp for ages now. Any help would be appreciated. Thanks a lot Andrew ___...___ Hotmail messages direct to your (...) (21 years ago, 13-Apr-03, to lugnet.robotics.rcx.legos)
| | | | | Re: Can an input be configured as an output?
|
| Hi Vik, An input has a 10K pull-up resistor to 5V in it. When nothing is connected to the input the A/D converter will return a value of about 1023 (which represents 5V). If you short the input (make sure it's in passive mode), you will get a value (...) (21 years ago, 11-Apr-03, to lugnet.robotics.rcx.legos)
|
|
