 | | BrickOS & LinuxUSB & lnpd
|
|
(i had a few problems to post, so this msg is a little too late...) Hi, i am new to brickOS, (since christmas) and i have one of those fancy RCX2.0 bricks with an USB IR-Tower. I am using debian and have little experiences with usb and (...) (22 years ago, 4-Jan-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: USB IR tower support in Lunix
|
|
Hi, I got the USB IR-tower to work under linux using the same patch Florian used. I also sent an updated patch that applies to 0.2.6.09 to the original author of the patch. However I have to caution that the said patch only works with UHCI hubs that (...) (22 years ago, 4-Jan-03, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Communication between RCX's with BrickOS
|
|
...Problem Solved #include <lnp/lnp-logical.h> lnp_logical_range(1); I set the IR transmission range to far and everything works fine. It seems the issue was that the RCX's are not facing eachother and depend on bouncing mesages off a wall. I'm (...) (22 years ago, 3-Jan-03, to lugnet.robotics.rcx.legos)
|
| |
| | makedepend variable in Makefiles
|
|
While attempting to build brickOS under DJGPP I noticed a few discrepancies across the makefiles using the variable makedepend. Under the directories boot, demo, demo/c++ for the .depend rule it uses the variable $(MAKEDEPEND) while the makefiles in (...) (22 years ago, 2-Jan-03, to lugnet.robotics.rcx.legos)
|
| |
| | Communication between RCX's with BrickOS
|
|
Hello Everyone, I have been working on a dual RCX robot for quite some time now, and have just recently upgraded to BrickOS. At first I attempted to used the LNP communication functions, such as lnp_adressing_write. I am not an expert, and I got (...) (22 years ago, 2-Jan-03, to lugnet.robotics.rcx.legos)
|
