|
|
 | | Re: transfer data failed
|
| I use 0.2.5 in windows (djgpp), and can't get by without using the slow download option (-s). If you have lighting problems, perhaps flipping the little switch on the IR tower will help. When I download stuff at school, it helps to have it set to (...) (23 years ago, 8-Aug-01, to lugnet.robotics.rcx.legos)
| | | | | Re: transfer data failed
|
| (...) I am using 0.2.4 under windoz and have had similar problems. I found that I must use the slow download option (-s) for the firmware to load properly. regards (23 years ago, 7-Aug-01, to lugnet.robotics.rcx.legos)
| | | | | Re: transfer data failed
|
| (...) Hi, i use 0.2.5 under Cygwin and sometimes i experience the same problem. I dont think its a problem with the legOS 0.2.4 distribution. The problem often occurs if its too dark or too bright in your room. It also happens if sender and receiver (...) (23 years ago, 7-Aug-01, to lugnet.robotics.rcx.legos)
| | | | | transfer data failed
|
| Hi there, I use legOS 0.2.4 under Linux and tried (after a few weeks) to download the firmware and get always the follwing error: firmdl3/firmdl: transfer data failed Batteries are brand new, tower was set to short and long dist. nothing helped ... (...) (23 years ago, 6-Aug-01, to lugnet.robotics.rcx.legos)
| | | | | Re: Is this an error in legOS 0.2.5?
|
| (...) a (...) Maybe, if you wanted to be really flash, when you get the (non-ultra) low battery warning, your robot could start seeking out the tower, and get ready to send the data. Maybe have a light near the tower that starts flashing when it (...) (23 years ago, 4-Aug-01, to lugnet.robotics.rcx.legos)
|
|
