| | Serious Collectors Only!
|
|
I'm selling my entire collection for $4,500. There are over 300 sets MISB, and over 200 sets opened but still in mint condition. Over 90% of the opened sets were put together once; and then sealed in zip-lock bags. The boxes of the MISB sets are in (...) (24 years ago, 29-Mar-01, to lugnet.robotics.rcx.legos)
|
|
| | Re: Assembly in my C-program
|
|
(...) If you want to drive directly the motors you should first disable motor handling in legOS (remove CONF_DMOTOR definition in config.h). Then you can create a high priority task that switches motors on and off writing in the motor output port. (...) (24 years ago, 28-Mar-01, to lugnet.robotics.rcx.legos)
|
|
| | Re: Assembly in my C-program
|
|
(...) pulses (...) at (...) would (...) Hmmmm. This should be possible, but it's a bit more tricky with stepper motors - you have to allow for the speed-up and slow-down. Thus just calling motor_speed(50) would have to initiate a task that starts (...) (24 years ago, 28-Mar-01, to lugnet.robotics.rcx.legos)
|
|
| | Re: Assembly in my C-program
|
|
Actually I am trying to control a stepper motor. So when i need to send 50 pulses fast, motor on and off takes same time because there same other tasks running at the same time. So it would be much quicker if I could just call motor speed (50), and (...) (24 years ago, 28-Mar-01, to lugnet.robotics.rcx.legos)
|
|
| | Re: Assembly in my C-program
|
|
(...) to (...) This should be performed by mapping a variable on top of the memory location, and NOT by inline assembly. (...) What is wrong with speed=0 for off and speed=255 for on? /jakob (24 years ago, 28-Mar-01, to lugnet.robotics.rcx.legos)
|