 | | Re: gcc build instructions for linux
|
|
(...) The helpful folks on the crossgcc mailing list told me that this error indicates that no libstdc was found, so no binary could be generated for the target (not host) platform. Since legOS provides a replacement library, there is no problem (...) (25 years ago, 7-Apr-99, to lugnet.robotics.rcx.legos)
|
| |
| | Re: gcc build instructions for linux
|
|
This site is quite useful: (URL) found it via ftp.cygnus.com/pub/crossgcc. I hope it helps you out. Cheers, Vic (...) LANGUAGES="c (...) that (...) (25 years ago, 7-Apr-99, to lugnet.robotics.rcx.legos)
|
| |
| | Re: gcc build instructions for linux
|
|
I got everything to build using egcs 1.1.2, but I am having problems with the tm-and-ir demo (after modifying it for the new execi syntax) which make me think maybe egcs is not generating correct code. I used the build instructions at (URL) did use (...) (25 years ago, 7-Apr-99, to lugnet.robotics.rcx.legos)
|
| |
| | Re: gcc build instructions for linux
|
|
(...) I did not have this problem. Sounds like Fortran. Did you 'make LANGUAGES="c c++"' or just 'make'? The latter makes the Fortran stuff, too. Remember that if you specify LANGUAGES when building, you should specify the same value when (...) (25 years ago, 6-Apr-99, to lugnet.robotics.rcx.legos)
|
| |
| | Re: gcc build instructions for linux
|
|
(...) I got the same message, and your reasoning about the content of the message sounds AOK by me. But then I did a make install, and that crudded out on me, with the message In file included from ../../../egcs-1.1.2/...com.c:198: (...) (25 years ago, 6-Apr-99, to lugnet.robotics.rcx.legos)
|
