| |
Sorry for my ignorance, but doesnt the datasheets mention that it
contains both analog and digital outputs and either may be used.
Ram
Jeffrey Hazen wrote:
>
> > From looking at the data sheets, it's going to be a bit more of a project
> than just "hooking it up". At a minimum you'll need to have a small micro
> to decode the dual PWM outputs, and they (AD) have a data sheet describing
> the use of a Parallax Basic Stamp. There will be a lot of algorithm
> development to turn the acceleration data into something useful, like say
> inertial navigation, and you'd eventually need a gyro to deal with rotation
> in the x-y plane. It would be an interesting project.
>
> My two Cents,
>
> Jeff
>
> Jeffrey Hazen
> North Mill Technology
> jeffrey.hazen@northmill.net
>
> -----Original Message-----
> From: Ram Meenakshisundaram [SMTP:rmeenaks@olf.com]
> Sent: Sunday, October 15, 2000 3:05 PM
> To: lugnet.robotics.rcx@lugnet.com; lugnet.robotics@lugnet.com
> Subject: Motion/Tilt Sensor from Analog Devices and the RCX
>
> Hi,
>
> I just order two free samples of Analog Devices ADXL202E at
> http://products.analog.com/products/info.asp?product=ADXL202. Anyone
> know if this can be hooked up to the RCX?
>
> Ram
>
> PS: Try to get a free subscription to "Sensors". It is a really cool
> magazine...
>
>
>
|
|
Message is in Reply To:
2 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
