RCX programmable brick : 652


Robotics / RCX / 652	651 \| 653

Subject:	Re: Expanding the available input/output ports of the RCX
Newsgroups:	lugnet.robotics, lugnet.robotics.rcx
Date:	Mon, 10 Jul 2000 01:16:05 GMT
Viewed:	825 times

Ram Meenakshisundaram schreef: > > Hi, > > With only 3 input and 3 output ports, the RCX becomes quite limiting after a > while. There are several different solutions to this at various sites. > Does anyone know which one is the best out of all of them. I basically > looking for good functionality and ease of use. Thanks.... You could use the sensors that came with the Cybermaster kit, they have a built-in resistor so it should be possible to hook up two of those on one input port and by using RAW values see which switch is pressed. -- Jan-Albert "Anvil" van Ree | http://www.nl.3dgamers.com 3D Sims Archive maintainer | http://www.3dgamers.com Thrustmaster Resource Center | http://www.3dgamers.com/tmresourcecenter/

Message is in Reply To:

		Expanding the available input/output ports of the RCX
Hi, With only 3 input and 3 output ports, the RCX becomes quite limiting after a while. There are several different solutions to this at various sites. Does anyone know which one is the best out of all of them. I basically looking for good (...) (24 years ago, 7-Jul-00, to lugnet.robotics, lugnet.robotics.rcx)

8 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search