 | | Help needed: Problems setting up the IR tower
|
|
I have changed my computer and it is imposible to get my IR tower up and running again. I have used my I tower with my old Pentium 233mmx/win95 with no problems at all (I have used the original lego software / NQC /WinlegOS). After changing my (...) (24 years ago, 13-Jun-00, to lugnet.robotics.rcx)
|
| |
| | Re: Help needed: Problems setting up the IR tower
|
|
Check your BIOS settings to see if those ports are enabled, maybe instead of auto set them manually in BIOS. Maybe soft reset is not enough to reset the port, but I doubt it, just to check it, unplug your box for couple of seconds. "Federico (...) (24 years ago, 13-Jun-00, to lugnet.robotics.rcx)
|
| |
| | Re: Help needed: Problems setting up the IR tower
|
|
I have tried both Andi Scharfstein´s and Reinis Kanders´ recommendations and everything seems ok but there was no improvement... The comm port works fine with my PalmPilot craddle but not with my IR tower...Does anyone else have another (...) (24 years ago, 14-Jun-00, to lugnet.robotics.rcx)
|
| |
| | Re: Help needed: Problems setting up the IR tower
|
|
(...) Have you already tried with a new 9V battery in the IR tower? Antonio (24 years ago, 14-Jun-00, to lugnet.robotics.rcx)
|
| |
| | Re: Help needed: Problems setting up the IR tower
|
|
Yes, I did but it didn´t work either... (...) (24 years ago, 16-Jun-00, to lugnet.robotics.rcx)
|
