 | | Re: RIS 2.0 PreAlpha SDK —Dean Husby
|
| | | (...) Thanks. I've noticed the Firmware File size is HUGE Almost 25K! Ouch... I've sent the following points already to the LEGO feedback. If any of you agree I strongly suggest you do the same. Power in numbers... "This is a comment on the (...) (25 years ago, 1-Apr-00, to lugnet.robotics.rcx)
|
| | | |
| | | | | Re: RIS 2.0 PreAlpha SDK —Dave Baum
|
| | | | (...) Check out page 7 of the LASM Byte Codes doc. They've added a lot more data "sources" including one for the battery level. This means you'll be able to use the battery level the same way you currently can read Timers, the Watch, etc. Too bad (...) (25 years ago, 2-Apr-00, to lugnet.robotics.rcx)
|
| | | | |
| | | | | | Re: RIS 2.0 PreAlpha SDK —Dean Husby
|
| | | | (...) Check out page 11. It states that it's DIRECT only. Not program. That's what I gather anyway... Dean -- Coin-Op's For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (25 years ago, 2-Apr-00, to lugnet.robotics.rcx)
|
| | | | |
| | | | | | Re: RIS 2.0 PreAlpha SDK —Dave Baum
|
| | | | (...) I believe the PBBattery() command is very different from using the Battery 'data source'. Specifically, the command is direct only (after all, there's no equivalent within a program for the response data from a command). However, data sources (...) (25 years ago, 2-Apr-00, to lugnet.robotics.rcx) !
|
| | | | |
