Subject:
|
Re: RIS 2.0 PreAlpha SDK
|
Newsgroups:
|
lugnet.robotics.rcx
|
Date:
|
Sun, 2 Apr 2000 02:51:09 GMT
|
Highlighted:
|
(details)
|
Viewed:
|
2120 times
|
| |
|
|
In article <38E68B07.BCDC2B85@akasa.bc.ca>, Dean Husby
<nntp@akasa.bc.ca> wrote:
> Ralph Hempel wrote:
>
> > In case anyone hasn't noticed yet....
> >
> > <http://www.legomindstorms.com/sdk2/index.html>
>
>
> Thanks.
>
> I've noticed the Firmware File size is HUGE Almost 25K! Ouch...
>
> I've sent the following points already to the LEGO feedback. If any of
> you agree I strongly suggest you do the same. Power in numbers...
>
> "This is a comment on the implementation of the Firmware.
>
> First, the command PBBATTERY states that it is DIRECT only.
Check out page 7 of the LASM Byte Codes doc. They've added a lot more
data "sources" including one for the battery level. This means you'll
be able to use the battery level the same way you currently can read
Timers, the Watch, etc.
Too bad its read-only, though. I was hoping to charge up my batteries
with software <g>
Dave Baum
--
reply to: dbaum at enteract dot com
|
|
Message has 1 Reply:
 | | Re: RIS 2.0 PreAlpha SDK
|
| (...) Check out page 11. It states that it's DIRECT only. Not program. That's what I gather anyway... Dean -- Coin-Op's For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (24 years ago, 2-Apr-00, to lugnet.robotics.rcx)
|
Message is in Reply To:
| | Re: RIS 2.0 PreAlpha SDK
|
| (...) Thanks. I've noticed the Firmware File size is HUGE Almost 25K! Ouch... I've sent the following points already to the LEGO feedback. If any of you agree I strongly suggest you do the same. Power in numbers... "This is a comment on the (...) (24 years ago, 1-Apr-00, to lugnet.robotics.rcx)
|
7 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
