 | | color sensor
|
|
hi all, first for all a happy christmas to everybody. I just ran into this nice looking color sensor TCS230, which might be useful for detecting Lego colors. (URL) Mientki (19 years ago, 25-Dec-05, to lugnet.robotics.rcx)
|
| |
| | Re: Bluetooth
|
|
Beware of the fact that the outputs on the RCX output PWM. You will probably want rectification, and need smoothing to get a nice constant voltage (some regulator in the LM series) to power the board. Anyway - it sounds like a really good idea - I (...) (19 years ago, 2-Dec-05, to lugnet.robotics.rcx)
|
| |
| | Re: Bluetooth
|
|
(...) Have a look at (URL) Here you reach much higher baud rates Cheers (19 years ago, 2-Dec-05, to lugnet.robotics.rcx)
|
| |
| | Re: Bluetooth
|
|
(...) Great! I'll look forward to its development....any ideas on what you will use it on first? Chris (19 years ago, 2-Dec-05, to lugnet.robotics.rcx)
|
| |
| | Bluetooth
|
|
I’ve just started a little project of building an interface between a RCX and a Bluetooth. For power supply I’m thinking of using one of the outputs on the RCX and for communication I’ll use the IR port(2400-baud), similar to Mindsensors´s RCX to (...) (19 years ago, 1-Dec-05, to lugnet.robotics.rcx)
|
| |
| | Help me convert this train program to use events (NQC)
|
|
For Christmas I'm setting up a LEGO train on top of a narrow wall, so it has to operate like a shuttle -- stop at each end and reverse motor direction. My first attempt had a train regulator attached to a polarity switch, with the switch being (...) (19 years ago, 28-Nov-05, to lugnet.robotics, lugnet.robotics.rcx, lugnet.robotics.rcx.nqc, lugnet.trains, FTX)
|
| |
| | Re: Problem with IR
|
|
(...) I tried adding -v & > output.txt but it didn't work. All it did was light up the towers LED for a bit then quit back to the command line. It did work when I used -v, showing all the sent bytes, but the download still failed. I also managed to (...) (19 years ago, 24-Nov-05, to lugnet.robotics.rcx)
|
| |
| | Re: Problem with IR
|
|
(...) Can you post the output generated by NQC when you add -v to the command line? nqc -Susb -TRCX2 -v -d filename.nqc > output.txt Or you could just email it to me directly. John Hansen (19 years ago, 24-Nov-05, to lugnet.robotics.rcx)
|
| |
| | Re: Problem with IR
|
|
(...) Ok, your right they are separate, so that if I left the second -Susb out, my program wouldn't download via the USB tower, but would go to my other RCX via the serial tower. My batch-file is this: nqc -Susb -firmfast c:\newrcx~1.lgo nqc -Susb (...) (19 years ago, 22-Nov-05, to lugnet.robotics.rcx)
|
| |
| | Re: Problem with IR
|
|
(...) Why couldn't it be that if the firmware downloads? When I download my firmware, it's completely seperate from when I download nqc progs. Hope you get it sorted soon. (...) (19 years ago, 22-Nov-05, to lugnet.robotics.rcx)
|
