 | | Re: DCC for the RCX
|
|
I just converted my first engine to DCC yesterday and started playing with LDCC 1.01. LDCC is fantastic! Thank you, Mark! I installed an AD330 N-Scale decoder from Model Rectifier Corp according to the directions on Tom Cook's site. At 0.8 Amps this (...) (21 years ago, 9-Jun-03, to lugnet.robotics.rcx, lugnet.trains)
|
| |
| | R: SPIRIT.OCX and embedded visual tools for winCE
|
|
I have developed a framework of classes in C++ that encapsulates the the RCX and its communication either from serial and from usb port. The framework is based on a proprietary library of fundation classes by SYCO called G++ that can be freely (...) (21 years ago, 6-Jun-03, to lugnet.robotics.rcx)
|
| |
| | SPIRIT.OCX and embedded visual tools for winCE
|
|
Hi there. I'm conscious that SPIRIT.OCX is quite old and that now there're another ways to control the RCX from any object oriented language on the computer side. I've tried those new methods and are quite good. In my opinion there's a big big point (...) (21 years ago, 5-Jun-03, to lugnet.robotics.rcx)
|
| |
| | Re: Remote control under linux
|
|
(...) Looking at your program, I see that you use code like the following to "run" a program: else if(data == P1) code0=0x91+alt; code1=0x00; send(2); This will only do half of the job. This is a "Set Program Number" opcode, which is the equivalent (...) (21 years ago, 3-Jun-03, to lugnet.robotics.rcx, FTX)
|
| |
| | Re: You must see LEGOTIC new LEGO site
|
|
Hi, (...) yes, I use one old VCR motor and 2 playing/recording heads. I' ve tested (see the small drawing on my site) with rotation sensor. It acts like gyros in helicopter or segway(but mine is "physic" and not "electronic"): it informs about angle (...) (21 years ago, 2-Jun-03, to lugnet.robotics.rcx)
|
