|
|
 | | Re: need help for MLCAD:"add new piece to library"
|
| (...) Chris, I thought that pneumatics parts had made it into the official parts release. When was the last time you updated your parts? I've been known to use parts from here: (URL) I prefer the parts made by JP Brown. You can get them off my (...) (22 years ago, 29-May-03, to lugnet.robotics.rcx)
| | | | | Re: DCC for the RCX
|
| (...) output? Dave, I used a 1N4002. It's a fairly common 1 amp switching diode. Here's a picture from my latest decoder install: (URL) that the banded end of the diode gets the blue lead from the decoder. The unbanded end gets the white lead. If (...) (22 years ago, 28-May-03, to lugnet.robotics.rcx, lugnet.trains)
| | | | | Re: DCC for the RCX
|
| In lugnet.robotics.rcx, Mark Riley wrote: <snip> (...) Mucho appreciated Mark. The Diode--any diode will do? and just solder it across the connector output? Take care, Dave (22 years ago, 28-May-03, to lugnet.robotics.rcx, lugnet.trains)
| | | | | Re: DCC for the RCX
|
| (...) I (...) resistors (...) goes (...) run (...) the (...) isn't (...) reduce the (...) David, When I installed my first decoders (Digitrax DN121), I omitted the capacitors, figuring if the buzzing was annoying, I could always add them later. As (...) (22 years ago, 28-May-03, to lugnet.robotics.rcx, lugnet.trains)
| | | | | Re: DCC for the RCX
|
| <snip> (...) Hey Esger I'm not an electronic specialist by any stretch of the imagination (though not by lack of trying) But commercially available DCC controllers and stuff mostly run at 12 volts (from the research I read), but the RCX runs at 9 (...) (22 years ago, 28-May-03, to lugnet.robotics.rcx, lugnet.trains)
|
|
