 | | Re: What sort of signals(values) can be transmitted and received by the RCX —Juergen Stuber
|
| | | (...) Yes. (...) No, integers are integers whether written decimal or hexadecimal (or in binary or whatever other base[*]). What you can do depends on the software you use. The SendMessage command in the standard firmware can send values in the (...) (22 years ago, 5-May-03, to lugnet.robotics.rcx)
|
| | | |
| | | | | Re: What sort of signals(values) can be transmitted and received by the RCX —Nick Tarleton
|
| | | | (...) 0x1 = 1. 0xf = 15. 0xbe = 11*16+14 = 190 (I think.) It's that simple. (...) But 0 is not recommended, as it's the value used when no message has been recieved. (...) brickOS is the best: it has LNP, an addressed protocol like UDP. (...) (...) (22 years ago, 5-May-03, to lugnet.robotics.rcx)
|
| | | | |
| | | | | | Re: What sort of signals(values) can be transmitted and received by the RCX —Juergen Stuber
|
| | | | (...) LNP is very nice, but as far as I understand it sends sequences of bytes and it is upon you to do the conversion to/from the data, where Lejos has some partial support on top of LNP. (...) If it weren't a coincidence then a mile would be (...) (22 years ago, 7-May-03, to lugnet.robotics.rcx)
|
| | | | |
