 | | Re: Firmware download troubles
|
|
Matt, I discovered that the IR LED's and detector on my serial tower was located higher than I expected and pointed upward somewhat. I was able to get better transfers when the tower was leaning forward (pointing downward so to speak). Otherwise, I (...) (22 years ago, 9-Dec-02, to lugnet.robotics.rcx)
|
| |
| | Re: Firmware download troubles
|
|
Also: When it seems to get to the very end before the error appears, I sometimes get a long (3-4 seconds) low tone from the RCX. Matt (22 years ago, 9-Dec-02, to lugnet.robotics.rcx)
|
| |
| | Firmware download troubles
|
|
Hi All, I have pulled my RCX out of summer storage and I am trying to bring it to life. I have tried to download the 2.0 Firmware (firm0328.lgo) dozens of times with no success. It starts to download, then somewhere in the middle, or very close to (...) (22 years ago, 9-Dec-02, to lugnet.robotics.rcx)
|
| |
| | Re: Ultimate Builders Set for Mac?
|
|
All the instructions on the UBS CD are jpegs and quicktime movs. This means that you can read them on a mac without using virtual PC, and if you have Quicktime Pro, you can join them all together as a slide show. Look on the CD in shared/build. I (...) (22 years ago, 9-Dec-02, to lugnet.robotics.rcx)
|
| |
| | Re: Ultimate Builders Set for Mac?
|
|
James, Thanks for the helpful info! If a PC is really needed only for reading the build instructions, do you think I could read them using Virtual PC running on my Mac? Dean (...) (22 years ago, 9-Dec-02, to lugnet.robotics.rcx)
|
