|
|
 | | Re: My RCX doesn't work!
|
| The green light always is on when I tried to find it, also when I boot PC, I think maybe the IR light is fault, what do you think? I also tried near 100 times, change different position, far or near, stand up and lie down tower or RCX/Scout, all are (...) (25 years ago, 23-Feb-01, to lugnet.robotics.rcx)
| | | | | About IR Tower
|
| I remember I connected to serial port without power off when I use IR tower every time, can it let IR tower get fault? Zhengrong (...) (25 years ago, 23-Feb-01, to lugnet.robotics.rcx)
| | | | | Re: My RCX doesn't work!
|
| I would replace the battery in the tower again. Watch the green light on the tower as you boot the computer. It should turn on once for a short time and then for a longer time as the boot sequence is completed. Check the cable connections at both (...) (25 years ago, 23-Feb-01, to lugnet.robotics.rcx)
| | | | | Re: My RCX doesn't work!
|
| Where can I buy IR tower? Zhengrong (...) (25 years ago, 23-Feb-01, to lugnet.robotics.rcx, lugnet.robotics)
| | | | | Re: My RCX doesn't work!
|
| I didn't say clear, I just used new battery both for tower and RCX, I tried my Scout at the moment, it also can't be detected, it seems the problem is in tower, May I need to change a new tower? Zhengrong (...) (25 years ago, 23-Feb-01, to lugnet.robotics.rcx)
| | | | | Re: My RCX doesn't work!
|
| I had the same Problem with my cybermaster after I took a new battery for the tower (no accu !) it worked fine again. Stefan (...) -- ***...*** Dipl.Inf. (FH) Stefan Prescher Fachhoschchule Oldenburg/Ostfriesla...helmshaven Fachbereich E+I / (...) (25 years ago, 23-Feb-01, to lugnet.robotics.rcx)
| | | | | My RCX doesn't work!
|
| I haven't used my RCX for a while, I found it doesn't work when I want to download firmware to it today. In fact, it is near non working! The RCX2 tools, nqc, lejos and WinNQC all can't find this RCX, but it can be found in 1% chance even if I put (...) (25 years ago, 23-Feb-01, to lugnet.robotics.rcx)
| | | | | Anybody tried ActiveX for Control Lab?
|
| Hello, I have just bought a Dacta Control Lab without software, so I use an ActiveX from (URL) I am having a bit of problems when I use "mindstorms" touch sensors. The ActiveX control wont registrer when I press it. Any hints? Lars Gertsen - Denmark (...) (25 years ago, 21-Feb-01, to lugnet.robotics.rcx, lugnet.robotics.rcx.robolab, lugnet.technic)
| | | | | Re: Got Motors?
|
| (...) I do beleive they mean eToys, try here: (URL) (25 years ago, 20-Feb-01, to lugnet.robotics.rcx.legos, lugnet.robotics, lugnet.robotics.rcx)
| | | | | Re: Got Motors?
|
| (...) Do you mean Toys-R-Us? And if so, where? Matthias Jetleb VA3-MWJ (25 years ago, 20-Feb-01, to lugnet.robotics.rcx.legos, lugnet.robotics, lugnet.robotics.rcx)
|
|
