|
|
 | | Re: direct manipulation of bits in RCX registers using NQC
|
| (...) Hi Brian, Thanks for your response. (...) I'm not sure if I get this, because of C code examples I've seen, which I'll discuss again below. (...) I've tried this already, and as you say, it works, but the sensitivity goes waay down. For a (...) (19 years ago, 13-Sep-05, to lugnet.robotics.rcx.nqc)
| | | | | Re: RCX to RCX NQC
|
| On Mon, September 12, 2005 8:03 pm, Brian Davis wrote: ... (...) ... Somewhere in there, it tells you the RCX will not accept the same command twice in a row. Each command has two op codes that are 8 digits apart. So (I think) for SetWatch you (...) (19 years ago, 13-Sep-05, to lugnet.robotics.rcx)
| | | | | Re: direct manipulation of bits in RCX registers using NQC
|
| (...) Perhaps - but the standard firmware implements a "virtual machine", and so you don't generally have access to physical registers. But... (...) You can configure the input port that the light sensor is connected to as a "passive" sensor (so (...) (19 years ago, 13-Sep-05, to lugnet.robotics.rcx.nqc)
| | | | | RCX to RCX NQC
|
| In a semi-followup to Steve's earlier "remote battery tester"... While the standard firmware provides almost no way to get bytes into the RCX (other than "Message()", one byte at a time), it can certainly export them ("SendSerial"). And it occured (...) (19 years ago, 13-Sep-05, to lugnet.robotics.rcx)
| | | | | direct manipulation of bits in RCX registers using NQC
|
| Hi all, Can anyone tell me if it is possible to use NQC to directly set bits in RCX registers? And if so, how does one do it? I've seen C code examples of this in a few places, but no NQC examples. Specifically, I want to turn on and off the red (...) (19 years ago, 12-Sep-05, to lugnet.robotics.rcx.nqc)
|
|
