|
|
 | | Re: Can the Run button be reprogrammed?
|
| (...) Not to put too fine a point on it, but RUN, PRGM and VIEW are read from an I/O port, while the ON/OFF button is tied to an interrupt line. That's what lets you wake the RCX up from a deep sleep, which you can't do with the other buttons. Ralph (20 years ago, 9-Feb-05, to lugnet.robotics.rcx)
| | | | | Re: Can the Run button be reprogrammed?
|
| (...) BrickOS does allow you to configure how the buttons are used. The RUN and Power buttons are read in the BrickOS "firmware", so you'd need to change the kernal, if you want to do other things with them, but it is very possible. So, yes, the run (...) (20 years ago, 9-Feb-05, to lugnet.robotics.rcx)
| | | | | Can the Run button be reprogrammed?
|
| I was just wondering, can the Run button on the RCX be reprogrammed? I was thinking of a theoretical, fail-safe system, where it would be nice to run a clean-up routine after the run button had been pressed to stop the program. I reckon you'd have (...) (20 years ago, 9-Feb-05, to lugnet.robotics.rcx)
| | | | | Re: Swan Firmware
|
| (...) No no, don't be. It's my own stupidity/ignorance in progrmaming terms. I'm slowly learning. (...) Good stuff, John. Thank you for your work on this, it's unbeliveable. I got it to do what I need. Now, the only problem is it doesn't seem to (...) (20 years ago, 9-Feb-05, to lugnet.robotics.rcx.nqc)
| | | | | Re: Sending Commands to Spybot from RCX - Question from a Beginner to Comm area.
|
| Hi Everybody, I have used SendSpybotMsg and SendSpybotCtrlMessage (of course in connection with resopective set messages) without any problems using BCC 3.3.7.5 and 3.3.7.9. These two commands gives RCX a nice control over spybot. Specially (...) (20 years ago, 8-Feb-05, to lugnet.robotics.spybotics, lugnet.robotics, lugnet.robotics.rcx, lugnet.robotics.rcx.nqc)
|
|
