Subject:
|
Re: Can the Run button be reprogrammed?
|
Newsgroups:
|
lugnet.robotics.rcx
|
Date:
|
Wed, 9 Feb 2005 16:52:31 GMT
|
Reply-To:
|
RHEMPEL@ihatespamBMTS.COM
|
Viewed:
|
5515 times
|
| |
|
|
> BrickOS does allow you to configure how the buttons are used. The RUN and Power
> buttons are read in the BrickOS "firmware", so you'd need to change the kernal, if
> you want to do other things with them, but it is very possible.
Not to put too fine a point on it, but RUN, PRGM and VIEW are read from
an I/O port, while the ON/OFF button is tied to an interrupt line.
That's what lets you wake the RCX up from a deep sleep, which you can't
do with the other buttons.
Ralph
|
|
Message has 1 Reply:
 | | Re: Can the Run button be reprogrammed?
|
| (...) Ultimate Robolab provides very easy access to the RCX buttons. With a few icons you can reprogram any of them. Here a nice example : (URL) you press the Run-button in this example, you'll here a sweep down system sound. This is the philosophy (...) (20 years ago, 10-Feb-05, to lugnet.robotics.rcx)
|
Message is in Reply To:
| | Re: Can the Run button be reprogrammed?
|
| (...) BrickOS does allow you to configure how the buttons are used. The RUN and Power buttons are read in the BrickOS "firmware", so you'd need to change the kernal, if you want to do other things with them, but it is very possible. So, yes, the run (...) (20 years ago, 9-Feb-05, to lugnet.robotics.rcx)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
