|
|
 | | Using the RCX for animating LEGO Train displays?
|
| Please pardon the interruption, as this is probably a bit off-topic, and is more a distraction than a contribution at this point. ;-) I've been looking in the various LUGNET forums, hoping to find a link to a good page of clues for using the RCX in (...) (20 years ago, 15-Jul-04, to lugnet.robotics.rcx)
| | | | | Re: Light Sensor question
|
| (...) Sam, By default programming when you configure a sensor input to be a light sensor, it gives you back readings in the 0-100 range (i.e. percentage of the maximum possible reading). To get better resolution (which I expect you might want), you (...) (20 years ago, 15-Jul-04, to lugnet.robotics.rcx)
| | | | | Re: Light Sensor question
|
| Thanks, I'm picking up my mindstorm kit today and if I run into any problems, I'll post another quesiton. (20 years ago, 15-Jul-04, to lugnet.robotics.rcx)
| | | | | Re: RCX datasheet
|
| Hallo Andreas, (...) not that I know of, but take a look at (URL) , that should answer most questions. This is about RCX 1.0, but the 2.0 is identical w.r.t. software and very similar w.r.t. hardware. If you have further questions, don't hesitate to (...) (20 years ago, 15-Jul-04, to lugnet.robotics.rcx)
| | | | | Re: Light Sensor question
|
| (...) Try a DIY CdS cell. See details here; (URL) (20 years ago, 14-Jul-04, to lugnet.robotics.rcx)
|
|
