 | | Re: DCC for the RCX
|
|
<snip> (...) Hey Esger I'm not an electronic specialist by any stretch of the imagination (though not by lack of trying) But commercially available DCC controllers and stuff mostly run at 12 volts (from the research I read), but the RCX runs at 9 (...) (21 years ago, 28-May-03, to lugnet.robotics.rcx, lugnet.trains)
|
| |
| | Re: DCC for the RCX
|
|
(...) As I run 12v stuff I dont know the 9v motor good enough to comment on the capacitors but I dont think it's that good an idea to use a resistor to drop the voltage. Use one or more (zener)diode's instead. Esger (21 years ago, 28-May-03, to lugnet.robotics.rcx, lugnet.trains)
|
| |
| | Re: Remote control under linux
|
|
(...) I'm not sure I understand the question. Are you saying that you want Program #1 to start when you press button P1 and stop running when you release the button? This isn't how the remote works, but you could just have your program send the Stop (...) (21 years ago, 28-May-03, to lugnet.robotics.rcx, FTX)
|
| |
| | need help for MLCAD:"add new piece to library"
|
|
Hi everybody, there are missing parts in my MLCAD library.For example I do not have small pneumatic cylinder or pneumatic switch. how can I get on? do I have to create my own custom part or is there any optional free library.If I create my own piece (...) (21 years ago, 28-May-03, to lugnet.robotics.rcx)
|
| |
| | Re: DCC for the RCX
|
|
(...) Oh My Goodness! This is what I've been waiting for--when I priced out DCC controllers, they were 200+ CDN... If I can get one of my many RCX's to do it, well that's entirely another matter. When I originally did the research and found the cost (...) (21 years ago, 28-May-03, to lugnet.robotics.rcx, lugnet.trains)
|
