 | | Re: RCX and GPS systems
|
|
(...) Also see the ACE-II from Trimble which could be powered and output directly to the normal sensor plugs; and can be run slow enough for it to nor be a problem to read. However... you are going to have issues with resolution and reception. (...) (22 years ago, 11-Oct-02, to lugnet.robotics.rcx)
|
| |
| | Re: RCX and GPS systems
|
|
A big question is if the positioning resolution you could achieve would be worth the cost or effort. The GPS hardware I've seen tell you where you are within a few yards. Unless you can get that down to a few inches what's the point? Plus you still (...) (22 years ago, 11-Oct-02, to lugnet.robotics.rcx)
|
| |
| | RCX and GPS systems
|
|
For sometime I have thought that a GPS interfaced with the RCX would be the answer to my navigational prayers. I have not found any information on an interface for the RCX (GPS-RCX or GPS-PC-RCX). I realize that this is not a trivial task with (...) (22 years ago, 11-Oct-02, to lugnet.robotics.rcx)
|
| |
| | Re: Cygwin/Gcc/Legos-0.2.6 Installation
|
|
(...) Something is definitely not quite right with your setup. Makefile.common in the util subdirectory of the BrickOS tree has the following code in it: # # WindowsNT/Cygnwin, test against several values: # ifneq (,$(findstring $(OSTYPE),cygwin32 (...) (22 years ago, 10-Oct-02, to lugnet.robotics.rcx.legos)
|
| |
| | Re: Cygwin/Gcc/Legos-0.2.6 Installation
|
|
Rick, I have never used 'make strip' and have been using legOS/BrickOS for quite some time now. So, if it doesn't work, that should not stop you from continuing. However, with BrickOS, the make strip command now executes 'strip fontdesign.exe (...) (22 years ago, 10-Oct-02, to lugnet.robotics.rcx.legos)
|
