 | | Re: decoding a message sent by an RCX
|
|
(...) I wondered about that - hardly any traffic in the newsgroup despite numerous downloads of NQC. I hope its because people are just too busy building stuff and programming it with NQC and RcxCC. Perhaps I should add a few more bugs to NQC just (...) (25 years ago, 5-Sep-99, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: RCX Currnet Rating?
|
|
(...) I'd bet you are safe with a 200 mA adapter. I have been using a 120 mA adapter for a while now with no problems. -Kekoa (25 years ago, 5-Sep-99, to lugnet.robotics.rcx)
|
| |
| | RCX Currnet Rating?
|
|
Hi, I have a 9V adapter that will fit the RCX. It has a current rating of 200mA. What is the current rating for ther RCX? I have seen adapters that are rated from 100mA up to 800mA. Thx...MJ (25 years ago, 4-Sep-99, to lugnet.robotics.rcx)
|
| |
| | Re: decoding a message sent by an RCX
|
|
(...) [...] I think something like this was already made by LEGO itself in the lab while creating the RCX/CyberMaster software. I say this because they seem to have forgot to remove the CABLE mode of transmission from the Spirit.ocx when deploying (...) (25 years ago, 4-Sep-99, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: decoding a message sent by an RCX
|
|
Woaw ! This could be great to have a full featured rcx expansion board... It should however be not too expensive, and in my opinion very basic to allow anything to be made. A "simple" (hehe :-) 8 bit Input / Output expander would be very, very nice. (...) (25 years ago, 4-Sep-99, to lugnet.robotics.rcx.nqc)
|
