 | | Re: RCXcc Missing "disconnect commport"
|
|
(...) Sorry about that, Stef. I'll put that menu option back in today. Thanks, John Hansen (23 years ago, 9-Jul-01, to lugnet.robotics.rcx.nqc)
|
| |
| | RCXcc Missing "disconnect commport"
|
|
hi John (Hansen or Binder ?) I used your RCXcc a few times, but I'm missing a very essential command (which was available in the orginal Mark Overmars RCXcc) "disconnect the commport". I can work around it, but this command could make things easier. (...) (23 years ago, 8-Jul-01, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: RCX Controlled Mobile De-coupler
|
|
I've just completed your version of the decoupler device and I must say that it's excellent! 8-wide train builders may want to modify this for clearance reasons though.-Harvey (23 years ago, 5-Jul-01, to lugnet.robotics.rcx, lugnet.robotics.scout)
|
| |
| | Re: Matlab and RCX
|
|
(...) I have done alot of MATLAB control stuff on SUN's. To control an RCX you will probably have to write a "Mex" interface in C. There is an inerface library for Visual Basic called sprit (??). If this can be accesed as a library from C then just (...) (23 years ago, 5-Jul-01, to lugnet.robotics.rcx)
|
| |
| | Re: constants for NQC using firmware 0328
|
|
(...) The wierd thing about the bytecodes provided by lego for direct serial communication (used by SendSerial() etc.) is that they are Tx only - there aren't any corresponding Rx capabilities. However, its possible that the 4800 baud setting is (...) (23 years ago, 4-Jul-01, to lugnet.robotics.rcx)
|
