 | | NQC and Fixed Point Values
|
|
My recent project, with NQC, has started to demand calculations with fractional numbers. In an effort to do this, I have quickly come to know the sorted world of floating points, BCDs, 1 – 2 s complement etc. I realize the only way to go about all (...) (23 years ago, 18-Apr-01, to lugnet.robotics.rcx.nqc)
|
| |
| | Re: Using 'containers' in Robolab
|
|
Thanks to you and Ben Irwin for your replies. After considerable beating my head against the wall I found my mistake: For the value in the angle container I had a constant instead of 'value of port 2' modifier. I surely will not forget that one. (...) (23 years ago, 18-Apr-01, to lugnet.robotics.rcx.robolab)
|
| |
| | Re: Electrical Data Link between 2 RCXs
|
|
It's me again with some improvements for an "Electrical Data Link between 2 RCX". In the current version I changed the default condition of the link to "high" (in the transmitter: OFF(OUT_B)) so that the receiver has a 1 at its sensor input. So, you (...) (23 years ago, 17-Apr-01, to lugnet.robotics.rcx.nqc)
|
| |
| | RE: New RcxCC revision posted
|
|
Hi, Ok, so, I got home, downloaded the .zip, installed it on my "LegoStation" (a 486 with RCX2 on COM2 and CyberMaster on COM3) over the last version. I think this was the "3.2 May 16th" Version. Started up, defined the window sizes and positions (...) (23 years ago, 17-Apr-01, to lugnet.robotics.rcx.nqc)
|
| |
| | error from makelx: address out of bounds
|
|
Hallo! My question again: I tried to declare sensors global, out of main(): Motor motor(Motor::B); LightSensor s(LightSensor::S3,false); int main(){ ... } make reports an error: /home/micha/legOS/util/makelx test.ds1 test.ds2 test.lx test.ds1: (...) (23 years ago, 17-Apr-01, to lugnet.robotics.rcx.legos)
|
