| |
> In the soon to be available new test release, BricxCC (3.3.7.17) now properly
> assumes NXC when a file has no extension if you switch your Preferred language
> for the standard firmware (on the Compiler|Common tab of the Preferences dialog)
> to be NXC. It also now assumes NXC when a file has no extension if the
> Preferred language for the standard firmware is set to NQC and your brick type
> is set to NXT.
Great!
> My apologies for allowing BricxCC to mislead at its best.
Of course my comment was not intended to be offensive... but I have pestered a
few times with that, so... ;o)
Philo
|
|
Message is in Reply To:
 | | Re: BricxCC release 3.3.7.16
|
| (...) In the soon to be available new test release, BricxCC (3.3.7.17) now properly assumes NXC when a file has no extension if you switch your Preferred language for the standard firmware (on the Compiler|Common tab of the Preferences dialog) to be (...) (18 years ago, 15-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
|
11 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
