Robotics : 26875


Robotics / 26875	26874 \| 26876

Subject:	Re: BricxCC release 3.3.7.16
Newsgroups:	lugnet.robotics, lugnet.robotics.nxt
Date:	Thu, 15 Feb 2007 19:24:18 GMT
Viewed:	9382 times

In lugnet.robotics, Philippe Hurbain wrote: > In lugnet.robotics, Patrick J. Levy wrote: > > It worked. > > > > The key was to save a file with .nxc extension... > > > Agreed, even if you select NXT target BricxCC insists to use .nqc as default > extension. Misleading at best... In the soon to be available new test release, BricxCC (3.3.7.17) now properly assumes NXC when a file has no extension if you switch your Preferred language for the standard firmware (on the Compiler|Common tab of the Preferences dialog) to be NXC. It also now assumes NXC when a file has no extension if the Preferred language for the standard firmware is set to NQC and your brick type is set to NXT. My apologies for allowing BricxCC to mislead at its best. John Hansen

Message has 1 Reply:

		Re: BricxCC release 3.3.7.16
(...) Great! (...) Of course my comment was not intended to be offensive... but I have pestered a few times with that, so... ;o) Philo (18 years ago, 16-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)

Message is in Reply To:

		Re: BricxCC release 3.3.7.16
(...) Agreed, even if you select NXT target BricxCC insists to use .nqc as default extension. Misleading at best... Philo (18 years ago, 13-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)

11 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search