 | | Re: motor command question
|
|
Hi Patty, I can't really answer this question other to say that I had exactly the same problem a while ago. I talked to LEGO tech support to no avail and they actually sent me a replacement block to fix the problem. However when I got it I had (...) (17 years ago, 3-Dec-07, to lugnet.robotics.nxt)
|
| |
| | Re: motor command question
|
|
Because the motors start to turn, then the program reaches the end, and exits. You need to tell the program to "wait for" something after the motors start. Steve (...) (17 years ago, 3-Dec-07, to lugnet.robotics.nxt)
|
| |
| | motor command question
|
|
Why would two motors, set to turn and with unlimited chosen for time out, only turn a couple of times and stop. this motor command is the only command in the program. patty (17 years ago, 3-Dec-07, to lugnet.robotics.nxt)
|
| |
| | Re: Nxc and Mindsensors stuff
|
|
(...) Thank you! But it worked only after firmware upgrade (to version 1.05) and using original NXT flat cables (Mindsensors flat cables are very poor quality). -- alf (17 years ago, 30-Nov-07, to lugnet.robotics.nxt)
|
| |
| | Re: recharging NXT battery block with DC adapter?
|
|
My NXT Charger came with my battery. The output of the charger is 10.8 volts, 700 ma 8W. I would just buy the Lego charger. After reaching a full charge, the charger goes into a trickle charge mode. "Pavel Petrovic" <pavel.petrovic@gmail.com> wrote (...) (17 years ago, 30-Nov-07, to lugnet.robotics.nxt)
|
