Subject:
|
Re: motor command question
|
Newsgroups:
|
lugnet.robotics.nxt
|
Date:
|
Mon, 3 Dec 2007 17:30:08 GMT
|
Viewed:
|
27380 times
|
| |
|
|
Because the motors start to turn, then the program reaches the end, and exits.
You need to tell the program to "wait for" something after the motors start.
Steve
On 12/3/07, Patty Van Dyke <patricia.e.vandykespamalot@verizon.net> wrote:
> Why would two motors, set to turn and with unlimited chosen for time out,
> only turn a couple of times and stop.
>
> this motor command is the only command in the program.
>
> patty
>
|
|
Message is in Reply To:
 | | motor command question
|
| Why would two motors, set to turn and with unlimited chosen for time out, only turn a couple of times and stop. this motor command is the only command in the program. patty (17 years ago, 3-Dec-07, to lugnet.robotics.nxt)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in NXT programmable brick
|
|
|
|
|
|
