 | | Re: bitwise operators
|
|
(...) Are you talking about NXC or NBC or some other programming language? The standard NXT firmware does support bitwise logical operators such as and, or, and xor. In both NXC and NBC you can use these operations as you would expect in a C-like (...) (18 years ago, 24-May-07, to lugnet.robotics.nxt)
|
| |
| | bitwise operators
|
|
I looked thru the doc, it looks like it does not allow bitwise operators like IOR, XOR, AND, etc. Is this correct? Or, I have overlooked something? --thanks Elizabeth (18 years ago, 24-May-07, to lugnet.robotics.nxt)
|
| |
| | RE: determine the degree of turning by using ultrasonic sensor
|
|
Ok... I wrap every sequence of motion control with mutex. I created a movement macro which basically just wrap the command(s) around with acquire and release. By the way, would someone tells me how I'll find out how the mutex datatype implemented. (...) (18 years ago, 22-May-07, to lugnet.robotics.nxt)
|
| |
| | RE: determine the degree of turning by using ultrasonic sensor
|
|
Found it... RotateMotor(OUT_C, 100, turn); x = MotorRotationCount(OUT_C); --E -----Original Message----- From: news-gateway@lugnet.com [mailto:news-gateway...ugnet.com] On Behalf Of Elizabeth Mabrey Sent: Tuesday, May 22, 2007 12:57 PM To: (...) (18 years ago, 22-May-07, to lugnet.robotics.nxt)
|
| |
| | determine the degree of turning by using ultrasonic sensor
|
|
Is it quick way to determining the # of degree or some value which will help to calculate the distance travelled. more or less like the x= rotation-click.. Is it a way to read how much the motor has turned from a certain point. - Reset motor/sensor (...) (18 years ago, 22-May-07, to lugnet.robotics.nxt)
|
