 | | RE: Using NXT Port 4 EIA-485
|
|
I've looked at implementing an interface for RobotC, but I've always struggled with why bother since there are no applications that connect to it. I wish LEGO had implemented an option to provide a logic level "RS-232" UART on port four. Yes, I (...) (17 years ago, 8-Apr-07, to lugnet.robotics.nxt, lugnet.robotics.nxt.nxthacking)
|
| |
| | Re: Using NXT Port 4 EIA-485
|
|
(...) As far as I know, there isn't any support for this interface in either the standard firmware or any of the other third party firmware implementations. The interface runs at 921,600 bps so it will be fast enough to be really useful. I am hoping (...) (17 years ago, 8-Apr-07, to lugnet.robotics.nxt)
|
| |
| | Re: NXT external storage
|
|
(...) It may work, but it will be very slow. The NXT runs the i2c ports at only 9600kb/s, so the data will trickle to the NXT very slowly. (...) I think that the answer is yes. (...) (17 years ago, 8-Apr-07, to lugnet.robotics.nxt)
|
| |
| | Re: NXT BrickSorter - Sorting bricks with a HiTechnic colour sensor.
|
|
(...) Thx for the comments. The design as it stands right now would not allow the sorter unit to rotate all the way around - not a bad idea though. I wanted to challenge myself with the angle idea on the sorter itself (2 rows of cups). With larger (...) (17 years ago, 8-Apr-07, to lugnet.robotics.nxt, FTX)
|
| |
| | Using NXT Port 4 EIA-485
|
|
Hi, is there currently any software-support (pbLua, NXT-G, NXJ) for NXT Port4 highspeed serial communication (EIA-485) ? This port can be used for connecting some new hardware (camera, SD-Card-storage) to the NXT... Thanks for more informations Bye (...) (17 years ago, 7-Apr-07, to lugnet.robotics.nxt)
|
