 | | RE: Two dimensional arrays in NXC
|
|
As an alternative, you might want to look at the ROBOTC solution. It fully supports two dimensional arrays. You can download a 30-day evaluation version from www.robotc.net. It's best to use the pre-release version (1.22 or higher) if you'll be (...) (18 years ago, 30-Mar-08, to lugnet.robotics.nxt)
|
| |
| | Two dimensional arrays in NXC
|
|
Hello, I'm trying to use two dimensional arrays in NXC, like this: int onedarray[4]; int twodarray[4][4]; task main() { onedarray[2] = 1; twodarray[2][2] = 1; } I read that the stock firmware doesn't support them, so I got John Hansen's enhanced (...) (18 years ago, 29-Mar-08, to lugnet.robotics.nxt)
|
| |
| | light active mode vs inactive mode
|
|
I am attempting to turn the reflective light on and off periodically. It works fine in RobotC. However, in Robolab, once it is turned off (via the robolab light sensor initialization - set the light on to "false"), it won't turn on again during (...) (18 years ago, 16-Mar-08, to lugnet.robotics.nxt)
|
| |
| | Using PF modes with mindsensors NRLink device
|
|
Hi all, I am trying to use the different PF modes (PWM for instance) with my mindsensors NRLink. I tried adding new macros to PF.txt file without any sucess. This is the file I used. I updated this macro file in my NRLink with NXT-G and afterwars I (...) (18 years ago, 14-Mar-08, to lugnet.robotics.nxt, lugnet.robotics)
|
| |
| | motor port splitter?
|
|
Looks like only Mindsensor provides port splitter for nxt motors. Unfortunately, this splitter will not allow independent control. I had this application which requires ita port to be attached to one NXT motor, and one RCX lamp (while the other two (...) (18 years ago, 10-Mar-08, to lugnet.robotics.nxt)
|
