Subject:
|
Re: Sharp GP2D12 and Expansion Board
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 12 Dec 2000 15:35:17 GMT
|
Viewed:
|
1495 times
|
| |
|
|
Also, all the digital ports and servo ports work perfectly on the expansion
board and everything works perfectly on the handyboard.
"Robin Chahal" <rchahal@hotmail.com> wrote in message
news:G5Goq4.B28@lugnet.com...
> I've identified the problem a little more but still no idea how to fix it.
>
> Analog ports 24 to 31 on the expansion board do not work at all.
>
> Analog port 16 on the expansion board works perfectly.
>
> If I gound the input to any of analog ports 16 to 23 on the expansion • board
> I get the value 0 from the commands _exp_analog(16) and _exp_analog(24).
>
> If I try to read any of the analog ports 17 to 23 I get the vallue 250 no
> matter what.
>
> I have tried changing all the chips on the board.
>
> Any ideas????
>
> I really don't know where to start.
>
>
>
>
>
>
> "Robin Chahal" <rchahal@hotmail.com> wrote in message
> news:G4y8MC.51D@lugnet.com...
> > Get a load of this...
> >
> > I have 2 handyboards and 2 expansion boards. I cut the traces to the • pull
> > up resistors for analog port 0 on both boards. One handyboard/expansion
> > board worked perfectly with the Sharp GP2D12 analog IR range finder. • With
> > the other one, the GP2D12 worked on analog(0) and analog(16) but on no • other
> > analog ports.
> >
> > Experiment:
> > I tried swaping the expansion boards to see what would happen. On both
> > handyboard/expansion boards the GP2D12 worked on analog(0) and • analog(16)
> > but no other ports. Very odd??? I swapped the boards back and the same
> > problem.
> >
> > I'm guessing I must have dammaged the second expansion board in some • weird
> > way when I swapped them the first time.
> >
> > Any ideas???
> >
> >
> >
>
>
|
|
Message is in Reply To:
 | | Re: Sharp GP2D12 and Expansion Board
|
| I've identified the problem a little more but still no idea how to fix it. Analog ports 24 to 31 on the expansion board do not work at all. Analog port 16 on the expansion board works perfectly. If I gound the input to any of analog ports 16 to 23 (...) (24 years ago, 12-Dec-00, to lugnet.robotics.handyboard)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
