Subject:
|
Re: Dificulties downloading to partially assembled board
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Fri, 23 Jun 2000 18:40:50 GMT
|
Reply-To:
|
glivick@(saynotospam)pacbell.net
|
Viewed:
|
1105 times
|
| |
|
|
The "fast" processors are legendary for having problems with loading IC pcode and
libraries. Probably, your board is fine.
Have you looked at the page on the HB website having to do with com problems?
It's at
http://lcs.www.media.mit.edu/groups/el/projects/handy-board/faq/winindex.html,
and is a good place to start. If you cannot get anywhere from there, then go to
my site and look at the "Basic Introduction to the TCOMP." This is a description
on how to get PCbug to run on the HC11 (along with some other helpful stuff). It
is written for my board (the Super T) but it will work just fine on the HB. It
won't help you solve your com problems, but it will tell for sure if your board
is working or not. After that, it's a matter of fiddling with the port settings
on your computer.
Don't give up. As soon as you get past this problem with communications, it gets
easier.
Gary Livick
Tiny HC11 products for your robot
http://www.teleport.com/~raybutts/
Robert Kelly wrote:
> I am at the point in construction where it asks you to test serial
> communications to the board before proceeding with memory installation. I
> hesitate to continue until I am comfortable with the workings of my board.
>
> When trying to establish comms, I get the message "board not responding,
> reconfigure board settings?".
>
> Please help, I am really perplexed here.
>
> Thanks,
>
> Bob Kelly
|
|
Message is in Reply To:
2 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
