To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 7364
  Re: PID Control
 
Hi Mike: May I obtain also the code that you mentioned? I'm supposing the code was used at the HandyBoard? Thanks in advance for your help... Victor G. Ruiz Aranda ruizvic@mx1.ibm.com IBM de Mexico S.A. Coordinador IAS Planta de Manufactura T/L (...) (25 years ago, 27-Jan-00, to lugnet.robotics.handyboard)
 
  RE: PID Control
 
This sounds like the sort of software that would be benifitial to everyone working with the Handyboard, perhaps it could be posted on the HB site? Fred? Reagrds, Matt (...) (25 years ago, 27-Jan-00, to lugnet.robotics.handyboard)
 
  Re: PID Control
 
(...) Yep ... and no. The following was applied to a pneumatic cylinder controlled via an Amplicon Liveline I/O card and an SMC proportional valve (ie not Lego). code ***...*** pidloop: 'e = error, sp = set point (desired value), pv = process value (...) (25 years ago, 27-Jan-00, to lugnet.robotics.handyboard)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR