 | | Re: sonar
|
| The location(C7) for the .1uF that you are refering to is located on the sonar driver board, on the lower left corner of the ribbon connector. Any non-polarized cap will do just fine. (...) (25 years ago, 24-Jan-00, to lugnet.robotics.handyboard)
| | | | | Re: sonar
|
| Just wondering... in reference to the modification on the Polaroid 6500 sonar ranging board, there's been two different assertions. Should the 0.1uF cap be of a polarized (e.g. electrolytic, tant, etc.) or non-polarized variety (as stated below)?... (...) (25 years ago, 17-Mar-00, to lugnet.robotics.handyboard)
| | | | | Re: sonar
|
| (...) I don't think it matters much. I used a 'lytic and it works fine. If you have another kind, it probably wouldn't hurt to give it a try. -- Will +---...---+ | ^^ <^ ^> | | / òó ó°° \ | | / =Y= U \ | | Wendy, Will, Tatoosh & Tenzing | (...) (25 years ago, 17-Mar-00, to lugnet.robotics.handyboard)
| | | | | IR emitters !
|
| Hi ! Can we connect two ir emitters to the HB IRout port (female connector J7) for left and right obstacle detection ? If so ! how do we distinguish between the left IR led and right IR led transmission since I'm planning to use only one Ir detector (...) (25 years ago, 18-Mar-00, to lugnet.robotics.handyboard)
| |
