Subject:
|
Re: Sensor questions
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 12 Jan 2000 19:41:02 GMT
|
Original-From:
|
Fabian Lopez <fabian@einstein.tvi.cc.SAYNOTOSPAMnm.us>
|
Viewed:
|
833 times
|
| |
|
|
You wrote:
I then tried the LM34. There is no calibration
pin and it uses farenheit. 1F=10Mv. For some reason, the output from
this device varies very little with changes in the room temperature. Now
the present room temperature is 58F, during the summer it was 78F. The
miniboard returned a value of 158 for both of these temperatures.
I have used LM34DZ temp sensors a fair number of times and have found
them to be simple to use and reliable. Perhaps the problem is the input
to the
ADC. I suspect impedance mismatch or you need to condition the signal
coming from
the temp. sensor -opamp amplifier circuit between the LM34DZ and the ADC
input?
Good Luck Fabian Lopez New Mexico
|
|
Message is in Reply To:
 | | Sensor questions
|
| I have several sensor questions. I would like to use my miniboard as an engine management system. At the present time, I have a small 2 cycle engine from a weed wacker that I would like to control. I would like to have the miniboard gather some (...) (25 years ago, 12-Jan-00, to lugnet.robotics.handyboard)
|
5 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
