Subject:
|
Re: com1 port settings to download pcode.hb.s19
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 23 Nov 1999 15:42:38 GMT
|
Viewed:
|
1093 times
|
| |
|
|
I did the test in the hyperTerminal and i couldn't get the com1 port. Do you
know how can i enable this port in windows nt?
In lugnet.robotics.handyboard, Fred G. Martin writes:
> did you try the Windows Serial Debug instructions, at
>
> http://el.www.media.mit.edu/projects/handy-board/faq/winindex.html
>
> this will at least tell you if the serial port is working at all. if you • don't
> see the "Direct to COM1" setting available in HyperTerminal, then Windows
> doesn't believe you have a serial port at all. this might be a problem in the
> System Registry or the CMOS configuration of the machine.
>
> fred
>
>
> In lugnet.robotics.handyboard, Lourdes Costa writes:
> > Hi,
> >
> > I am here struggling to connect the handyboard with my computer. I am trying
> > download pcode.hb.s19
> > In com1 port, but i am receiving a message that it can't open the port.
> >
> > I think that the settings of my com1 port is wrong. They are:
> >
> > Band rate = 9600
> > Data base = 8
> > Parity= none
> > Stop bits =1
> >
> > Base I/O port adress 3f8
> > Interrupted request line 15
> > X Fifo Enable.
> > Or maybe the windows nt is not recognizing the hardware serial port but i • don't
> > know how can i do to make it recognized
> >
> > Please, if anyone knows what is going on with my port, please send me a tip, • i
> > will be grateful. The plataform is NT.
> >
> > Thanks,
> >
> > Lourdes Costa
> > Parsons School of Design
|
|
Message is in Reply To:
5 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
