Subject:
|
Re: com1 port settings to download pcode.hb.s19
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 21 Nov 1999 17:56:03 GMT
|
Viewed:
|
961 times
|
| |
|
|
did you try the Windows Serial Debug instructions, at
http://el.www.media.mit.edu/projects/handy-board/faq/winindex.html
this will at least tell you if the serial port is working at all. if you don't
see the "Direct to COM1" setting available in HyperTerminal, then Windows
doesn't believe you have a serial port at all. this might be a problem in the
System Registry or the CMOS configuration of the machine.
fred
In lugnet.robotics.handyboard, Lourdes Costa writes:
> Hi,
>
> I am here struggling to connect the handyboard with my computer. I am trying
> download pcode.hb.s19
> In com1 port, but i am receiving a message that it can't open the port.
>
> I think that the settings of my com1 port is wrong. They are:
>
> Band rate = 9600
> Data base = 8
> Parity= none
> Stop bits =1
>
> Base I/O port adress 3f8
> Interrupted request line 15
> X Fifo Enable.
> Or maybe the windows nt is not recognizing the hardware serial port but i don't
> know how can i do to make it recognized
>
> Please, if anyone knows what is going on with my port, please send me a tip, i
> will be grateful. The plataform is NT.
>
> Thanks,
>
> Lourdes Costa
> Parsons School of Design
|
|
Message has 2 Replies:
Message is in Reply To:
 | | com1 port settings to download pcode.hb.s19
|
| Hi, I am here struggling to connect the handyboard with my computer. I am trying download pcode.hb.s19 In com1 port, but i am receiving a message that it can't open the port. I think that the settings of my com1 port is wrong. They are: Band rate = (...) (25 years ago, 21-Nov-99, to lugnet.robotics.handyboard)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
