Handy Board : 7106


Robotics / Handy Board / 7106	7105 \| 7107

Subject:	com1 port settings to download pcode.hb.s19
Newsgroups:	lugnet.robotics.handyboard
Date:	Sun, 21 Nov 1999 17:34:53 GMT
Viewed:	928 times

Hi, I am here struggling to connect the handyboard with my computer. I am trying download pcode.hb.s19 In com1 port, but i am receiving a message that it can't open the port. I think that the settings of my com1 port is wrong. They are: Band rate = 9600 Data base = 8 Parity= none Stop bits =1 Base I/O port adress 3f8 Interrupted request line 15 X Fifo Enable. Or maybe the windows nt is not recognizing the hardware serial port but i don't know how can i do to make it recognized Please, if anyone knows what is going on with my port, please send me a tip, i will be grateful. The plataform is NT. Thanks, Lourdes Costa Parsons School of Design

Message has 2 Replies:

		Re: com1 port settings to download pcode.hb.s19
did you try the Windows Serial Debug instructions, at (URL) will at least tell you if the serial port is working at all. if you don't see the "Direct to COM1" setting available in HyperTerminal, then Windows doesn't believe you have a serial port at (...) (25 years ago, 21-Nov-99, to lugnet.robotics.handyboard)

		Re: com1 port settings to download pcode.hb.s19
I think the IRQ is not ok. ----- Original Message ----- From: lourdes Costa <loucosta@earthlink.net> To: <handyboard@media.mit.edu> Sent: Sunday, November 21, 1999 6:34 PM Subject: com1 port settings to download pcode.hb.s19 (...) trying (...) don't (...) (25 years ago, 21-Nov-99, to lugnet.robotics.handyboard)

5 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search