| |
Danny ... does your HB work when it is NOT connected to the serial
board or the charger?
- Nick -
Danny Gratton wrote:
>
> Okay, I'll try it. Do I need to have the DC adapter plugged in to the
> Handyboard?
> In lugnet.robotics.handyboard, Fred G. Martin writes:
> > ok, you have the stock adapter.
> >
> > like i said, sometimes the batt does get fully charged and then not
> > enough current flows in trickle-charge to light the LED.
> >
> > but that's normal, so it doesn't sound like there is actually a
> > problem.
> >
> > a simple way to test the batt is do a run-down test. just leave the
> > board on and see how long the batt lasts. you should get approx 10
> > hours with the board sitting there doing nothing (just the Interactive
> > C heart beating).
> >
> > fred
> >
> > In your message you said:
> > > Well I bought an assembled board from Gleason Research and I've been using • th
> > e
> > > DC adapter that came with the board. The charging leds light up only when • the
> > > Handyboard on? Is there something special I need to do to run the board on
> > > batteries? Is there a way I can test the batteries?
> > >
> > > lugnet.robotics.handyboard, Fred G. Martin writes:
> > > > do you have the recommended 12v, 500 ma DC adapter?
> > > >
> > > > if not, that explains it.
> > > >
> > > > if so, sometimes when the batt is fully charged, you don't get much in
> > > > trickle charge mode and the light is off. but usually you should see
> > > > the light being lit dimly.
> > > >
> > > > are you having problems with your battery holding a charge?
> > > >
> > > > fred
> > > >
> > > > In your message you said:
> > > > > In the Handyboard manual it says when charging in trickle mode you should • tur
> > > > n
> > > > > the Handyboard off, however when I do try and turn the Handyboard off the
> > > > > charge light on the serial/charger board goes off? Is the board still • bei
> > ng
> > > > > charged or is there a problem?
> > > > >
> > > > > The same problem occurs when I charge the Handyboard directly. If the • pow
> > er
> > > > > switch is turned on the charge light(LED) is on however when it's turn • off
> > > th
> > > > e
> > > > > charge light goes off? What's the problem?
> > > > >
> > > > > When the batteries are charged should the board be able to run withought • a
> > n
> > > > > external power supply?
> > > > >
> > > > > Any information would be great!!!
> > >
> > >
|
|
Message is in Reply To:
8 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
