 | | Motor Controller Question —Bruce Moore
| | | | From what I could figure out from the literature on the HB, the motor controller circuit is controlled by Port B on the 6811. With a little tinkerin last nite I was trying to set/reset some of the pins poking values into $1004 (Got this from "An (...) (25 years ago, 13-Oct-99, to lugnet.robotics.handyboard)
| | | | | | | | | | Re: Motor Controller Question —Fred G. Martin
| | | | | bruce, for the HB you need to write data to $7000 to control the motors. see appendix B of the 6.270 manual at (URL) also the HB FAQ (URL) your message you said: (...) (25 years ago, 13-Oct-99, to lugnet.robotics.handyboard)
| | | | | | |
