Subject:
|
using IC
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 2 Jun 1999 18:08:17 GMT
|
Original-From:
|
saroyan@us.+NoSpam+ibm.com
|
Viewed:
|
820 times
|
| |
| |
I'm using IC to program the Handy Board but I have run into a slight problem.
How do I undefine a "main" from the board so that I can define another "main" if
I can't remember the name of the window I downloaded that had the wrong "main"
on it?
Thanks for your help!
Salpi
|
|
Message has 3 Replies: | | Re: using IC
|
| Hi Salpi, if you hold down the 'start' button while switching on your Handy Board, the code defined in "main" that is in Handy's memory at that time, will not run. You can then download a new program to your Handy Board and run it. Success, Marc (...) (25 years ago, 2-Jun-99, to lugnet.robotics.handyboard)
| | | Adding more meemory
|
| I have one quesion is i possible to add another 32k ram chip to the handyboard? can IC acces this chip?, I understand that you use the existing address lines and add an inverter on the CE signal and rout it to another chip. Has anybody done this and (...) (25 years ago, 2-Jun-99, to lugnet.robotics.handyboard)
| | | Re: using IC
|
| (...) the code (...) You can then (...) On the same note, there is a list files command that you can use at the command propmpt in IC to indicate which files are loaded. Then unload will remove whatever offending file. best, Duncan (25 years ago, 2-Jun-99, to lugnet.robotics.handyboard)
|
5 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|