Subject:
|
Re: Servos and solenoids
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Fri, 19 Feb 1999 03:23:18 GMT
|
Original-From:
|
Wayne Rademacher <ridgetec@net-STOPSPAMinfo.com>
|
Viewed:
|
3203 times
|
| |
|
|
I won't attempt to power your servos with 9v. Those servos are designed to
work off a 4.8v battery pack, you'll most likely smoke'm.
Wayne
-----Original Message-----
From: J.W. Pennington <jwp@awod.com>
To: handyboard@media.mit.edu <handyboard@media.mit.edu>
Date: Thursday, February 18, 1999 8:56 PM
Subject: Servos and solenoids
> First,
> The Handyboard's motor output is 9 volts, does anyone know if Futaba's
> small servos handle this well? I have two S3003 servos that I'd like to
> use.
>
> Second,
> Has anyone run a solenoid from a motor output? I'm assuming that it
> would do fine, PWM would just keep it fixed until the low end. Also,
> what voltage range do I have for a servo? Too much for a 3 volt, not
> enough for a 12 volt?
>
> Thanks!
> --
> ________________________________________
> Jonathan Pennington
> -Anthropologist/Geologist
> -Linux User and Advocate
> -Bart Simpson Sympathizer
>
> Email at jwp(at)awod.com
> _______________________________________
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
