Subject:
|
Servos and solenoids
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Fri, 19 Feb 1999 02:45:30 GMT
|
Original-From:
|
J.W. Pennington <jwp@awod!IHateSpam!.com>
|
Viewed:
|
1193 times
|
| |
|
|
First,
The Handyboard's motor output is 9 volts, does anyone know if Futaba's
small servos handle this well? I have two S3003 servos that I'd like to
use.
Second,
Has anyone run a solenoid from a motor output? I'm assuming that it
would do fine, PWM would just keep it fixed until the low end. Also,
what voltage range do I have for a servo? Too much for a 3 volt, not
enough for a 12 volt?
Thanks!
--
________________________________________
Jonathan Pennington
-Anthropologist/Geologist
-Linux User and Advocate
-Bart Simpson Sympathizer
Email at jwp(at)awod.com
_______________________________________
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
